More information on mites

Editor’s note: This article is from the archives of the MSU Crop Advisory Team Alerts. Check the label of any pesticide referenced to ensure your use is included.    

Life cycle

Spider mites overwinter as adults. In spring, they move to new plant growth and lay eggs on the undersides of leaves. (see photo) Mites can be blown by wind, so initial colonization of a field will often occur in the direction of prevailing winds, or along landscape features that disrupt air flow, such as tree lines, houses or even telephone poles. Infestations usually start on dusty edges of fields. It is thought that dust dries the leaf surface, protecting mites from disease, or perhaps that the dust provides a surface for the mites to anchor their webs. With a hand lens or microscope, you can see that webbing acts like an interstate highway with mites moving back and forth above the leaf surface.

Eggs hatch in a few days and small mites begin to feed. Immature mites resemble the adults, except that they are smaller in size. They grow by molting, and if you look closely at a mite-infested leaf, you sometimes see the shed skins of immature mites. A leaf heavily colonized by mites will have eggs, immatures, adults, shed skins and webbing.

Damage

Spider mites feed on numerous crops, and under certain conditions, will increase to the point where they affect yield. This is especially true under dry conditions or on sandy soils where water stress is an issue. Mites pierce individual plant cells and suck out the contents, initially causing tiny yellow spots (called stippling) on leaves. This feeding also increases water loss from the plant. As populations increase, symptoms include yellowing of leaves, and in more severe cases browning, bronzing or death of foliage. As leaves become yellow and die from mite damage, the photosynthetic ability of the plant is reduced. With the additional water loss, leaf drop and reduced photosynthesis, yield and quality of crops is reduced by severe mite feeding.

Scouting

If an infestation is identified early, spot treatments of the affected area plus a border strip may be enough to take care of mites. Otherwise, if mites spread across a field, the treatment threshold for dry bean is 25% of the plants infested with mites, with yellowing. For soybean, estimate the percentage of leaf surface damaged by mites. Treatment thresholds (based on % yellowing) vary with plant stage: pre-bloom = 40%; bloom R1 to pod fill R5 = 15%; R5 to early maturity R7 = 25%; after R7 = Do Not Spray. Damage at this point has little impact on yield. An alternative handy evaluation scheme (originally from Ohio State) for mites in soybean is printed in the accompanying table.

Ohio State evaluation scheme for mites in soybean
(Originally printed in the C.O.R.N. Newsletter)

Presence of mites

Damage

Assessment

Barely detected on undersides of leaves in dry locations or on edges of fields.

Barely detected.

1 - Non-economic

Easily detected on undersides of leaves in dry locations or on edges of fields. Difficult to find on leaves within the field.

Foliage green, but stippling injury detectable on undersides of leaves, although not on every plant.

2 - Non-economic, but keep monitoring

All plants are infested when examined closely.

All plants in field exhibit varying levels of stippling, even on healthy leaves. Some speckling and discoloration of lower leaves. Field margins and dry areas exhibit severe damage.

3 - Rescue treatment is warranted, especially if many immatures/ eggs are present.

All plants heavily infested when examined closely.

Discolored and wilted leaves easily found throughout the field. Severe damage evident.

4 - Effective rescue treatmentwill save field.

Extremely high numbers.

Field discolored, leaves drying down. Significant foliage and stand loss.

5 - Rescue treatment may not save field.

However, new growth may resume if treated.

Chemical controls

Mite control is difficult, and more than one application may be needed. Unfortunately, multiple applications are a losing proposition and can lead to resistance. Later in the season, spraying becomes more difficult due to closing of the canopy, and spraying is also less effective as plants mature (yield is no longer affected).

  • Dry beans: dimethoate (0.5 – 1 pint/ acre). Will also control potato leafhopper.
  • Sugar beets: Lorsban (1-2 pints/ acre)
  • Soybeans: Lorsban (0.5 – 1 pint/ acre) or dimethoate (1 pint/ acre)

Biocontrol

What about natural controls? A heavy rain may reduce the population a little, but don’t depend on rain alone. The real key is high humidity, since the fungal pathogens that kill mites require high, sustained humidity to grow and spread through the population. A brief rain, followed by quick drying, does not provide a long enough period for diseases to spread and kill a significant portion of the mite population. Instead, you need a sustained rainy pattern, or repeated dewy wet mornings.

Related Events

Related Articles

Related Resources